In this study, the AZ31 rods with gradient distributions of stored dislocations, {10–12} twins and texture components are fabricated by the free-end-torsion processing firstly. Influences of annealing treatment on the gradient microstructures and mechanical properties are then investigated. The results show that the annealing does not vary the torsion-deformed textures, but may cause recovery and recrystallization motivated by releasing of the stored dislocations. And the recrystallization behavior closely depends on the shear strain. High shear strain can generate high stored energy and increase the thermal mobility of {10–12} twin boundaries, resulting in the reduction of recrystallization temperature and promotion of nucleation. After annealing, recrystallization grain size gradually decreased from center to edge positions. Prior to annealing, the gradient hardness distribution in torsion-deformed sample is mainly attributed to the gradient dislocations. After annealing, grain size becomes the dominated factor for the hardening. Torsion deformation can almost eliminate yield asymmetry without the loss of strength and plasticity. Remarkable low yield asymmetry can be ascribed to grain refinement by twins and the textural change. With increasing annealing temperature up to 300 °C, yield asymmetry increases continuously owing to the grain growth induced by the static recrystallization. Finally, the relevant mechanisms are investigated and discussed.
http://www.sciencedirect.com/science/article/pii/S0921509317302009
转载本文请联系原作者获取授权，同时请注明本文来自郭宁科学网博客。
链接地址：https://m.sciencenet.cn/blog-58154-1037649.html?mobile=1
收藏
